9850
Wiring your VFD (not purchased from MachMotion)
If you purchased a VFD from MachMotion, all labeling is done and you will not need this information.
However, if you have your own VFD, you may use the following information to match to your VFD inputs (consult your manual or VFD manufacturer/supplier for proper connections).
See image below or attached for wiring a VFD to our Apollo III board:
The following table could be copied/printed to help you match your connections with ours:
| Function | Analog 0-10VD C | CW Relay | CW Relay | Drive Enable | GND | N/C | CCW Relay | CCW Relay |
|---|---|---|---|---|---|---|---|---|
| RJ45 Pins | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| Colors | White & Orange | Orange | White & Green | Blue | White & Blue | Green | White & Brown | Brown |
| Connections |
We also have a couple examples attached you can use to get a better understanding of the needed connections and compare with your unit.
We have gone through great lengths to help you connect your VFD at our expense. If you require more assistance than this you would need to contact the manufacture of your unit, purchase a VFD from us, or we may be able to help further with yours for an additional engineering fee.