7662

Oiler Setup

Description of the problem:

Setting up an oiler.

Solution:

To set up and enable the oiler function:

1. Go to PlugIn Control->MachMotion Config->I/O Configuration
2. Select the desired output to use to control the oiler (do not use output 1 or 2)
3. Select the desired condition for enabling timer (typically On Spindle is used)
4. Set the time (in seconds) you want the oiler to be on every cycle
5. Set the cycle time (in minutes) you want the oiler to run at

NOTE: Time on happens first, then the time off counter begins. If you close out of Mach software, the timers start over.